Post reply

extra blank page in print layout

  • May 21, 2012 at 12:36 pm

    #269249

    hi

    i am getting extra 1 blank page in print layout.

    i am seeing data on first ,then second blank and third i have data.

    how to avoid this page?

  • May 21, 2012 at 12:40 pm

    #1490613

    riya_dave (5/21/2012)

    hi

    i am getting extra 1 blank page in print layout.

    i am seeing data on first ,then second blank and third i have data.

    how to avoid this page?

    Bring the right hand edge of your report in. The extra page is due to the report width being greater than your printable page size. If you had anything on the page then you would see the pages see by side. As its blank then the report s too wide.

    Fitz

  • May 21, 2012 at 12:47 pm

    #1490621

    thanks .got solve it

  • May 21, 2012 at 12:52 pm

    #1490632

    additional question ,regarding spaces in report.

    in my report i have 1 tablix ,above it i have textbox,in which i have tablix title.

    now in design ,there is no gap between title and tablix.

    but in print layout,i am seeing huge gap ,and cant figure it out ,how it shows different than design

  • May 21, 2012 at 2:11 pm

    #1490705

    riya_dave (5/21/2012)

    additional question ,regarding spaces in report.

    in my report i have 1 tablix ,above it i have textbox,in which i have tablix title.

    now in design ,there is no gap between title and tablix.

    but in print layout,i am seeing huge gap ,and cant figure it out ,how it shows different than design

    Go back and have a look at the report. My guess is that the textbox (header) is mutliple lines (i.e. you have pressed return in it) and it is overlapping the tablix. Reporting Services resolves this conflict only at preview time. Reduce the height of the header textbox so that it does not overlap.

    Fitz

  • May 22, 2012 at 8:09 am

    #1491104

    i remove overlap ,but still getting space.

    any other reason

  • May 22, 2012 at 9:42 am

    #1491174

    i remove overlap ,but still getting space.

    any other reason

  • May 22, 2012 at 11:06 am

    #1491236

    Use this formula to make sure your data is not spilling over onto a blank page.

    body size + left margin + right margin <= page width.

    You can get the body size by turning on the ruler and looking at the total width of the reoprt. You can get the margin sizes and the page/paper width in the report properties.

  • May 22, 2012 at 11:25 am

    #1491243

    riya_dave (5/22/2012)

    i remove overlap ,but still getting space.

    any other reason

    Not without getting access to the report design.

    Fitz

Viewing 9 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic. Login to reply